Visual Inspection Level II – General exam

 Visual inspection of a fabricated item, for a high integrity application, should cover inspection activities ………

 All of the following are weld joints except

A convex weld surface:

The welding process in which there is a higher degree of probability of entrapping slag is:

Tungsten inclusions are found during:

A welding process in which shielding is provided by the electrode covering is called:

A slag-type discontinuity is produced by:

Failure to adequately penetrate the weld root of a groove weld is called:

A disadvantage of the GMAW process is:

Cracks can occur in:

On a welding symbol, the flag symbol indicates:

The heat affected zone is the portion of the portion of the:

A solid inclusion in a weld may be …….

 The Ultimate Tensile Strength of E8010 is

The welding positions that E8010 can be used in are…..

GTAW usually uses ……. gas for shielding the weld pool

Tungsten electrode in GTAW process is also known as

Which of the following welding processes is considered to have the most deposition rate (highest productivity)

Which of the following processes is considered to be having the best weld quality

Which type of power supplies that GMAW process usually use

Which of the following gases is not commonly used as a shielding gas for GTAW?

Which of the following is not a type of metal transfer in GMAW?

A discontinuity that is not associated with welds is:

– A discontinuity with a small star-shaped pattern where a weld starts or stops is usually an indication of:

 During a visual examination, a welding discontinuity that could not be detected would be:

Which type of power source characteristic is normally used for manual welding

In order to render valid results, visual examination must include a:

In welding, weld metal protrusion beyond the fusion line at the weld toe is called:

Cracks, suckback, undercut, and overlap are discontinuities found in:

Cracking under the combined action of corrosion and tensile stress is referred to as:

A groove formed at the toe or root of a weld when the base metal is melted away and left unfilled by weld metal is referred to as:

A basic metallurgical joint configuration that is used for complete joint penetration is called:

The welding process that is sometimes referred to as “stick welding” is:

The portion of base metal that has not been melted but where mechanical properties or microstructure have been altered by the heat of welding is defined as:

A cause for undercut that occurs during the welding process is calles:

A rounded discontinuity that occurs in the weld and is then distributed in line, paralled with the weld is called:

The gage that is typically used to measure the face reinforcement of a butt joint is:

What welding alternative of the following in SMAW is changed with the arc length ….

Undercut may need to be assessed according to ………..

When visually inspecting the root bead of a single-vee-butt weld it should be checked for ……….